济南精拓流体设备有限公司

网站公告:

产品中心

济南精拓流体设备有限公司

济南精拓流体设备有限公司电话:0531-69951198

邮箱:jingtuolt@163。com

传真:0531-69951198

地址:济南市历城区西周南路9号

网址:http://www.lesmills8.com

正确使用气体增压泵需要哪些布置?

发布时间:2019-07-02 11:44:49   发布人:济南精拓流体设备有限公司http://www.lesmills8.com
一、装置位置
I. Device Location
气体增压泵可以装置在任何位置,但为保证密封件到达长的运用寿命,倡议采用垂直装置方式。
Gas booster pump can be installed in any position, but in order to ensure the longest service life of sealing parts, it is advocated to adopt vertical device.
二、接口尺寸很重要
2. Interface size is very important
请确认所装置的螺钉和管能否合适泵的压力范围。为保证气驱泵取得理想的流量和压力,不能减小泵的接口尺寸
Please make sure that the screw and pipe of the device are suitable for the pressure range of the pump. In order to ensure the ideal flow rate and pressure of gas drive pump, the interface size of pump can not be reduced.
衔接驱动空气与开端运转
Connection drives air and start-up operation
气体驱动接口位于滑阀室外部。
The gas drive interface is located outside the sliding valve chamber.
由于气体增压泵的体积比拟小,因而不只能够用其准确控制压力,而且还能够用来准确地定位控制仪器。在任何状况下,都需装置一个紧缩空气过滤器和水别离器,也可选配气控单元:包含装备水别离器的过滤器,减压阀、压力表、截流阀等
Because the volume of the gas booster pump is comparatively small, it can not only control the pressure accurately, but also be used to locate the control instrument accurately. In any case, it is necessary to install a compact air filter and water separator, and the air distribution control unit can also be selected: filter equipped with water separator, pressure reducing valve, pressure gauge, shutoff valve, etc.
由于气驱泵经过油脂光滑处置,因而无需装置空气润湑器。如运用过一次空气润湑器,则引荐继续运用。如运用很枯燥的气体,则须运用气体光滑器。
气体增压泵
Because the gas drive pump is smoothly disposed of by grease, there is no need to install air humidifier. If the air humidifier has been used once, it is recommended to continue to be used. If very dull gas is used, a gas smoother must be used.
三、气体增压泵的操作温度
3. Operating Temperature of Gas Booster Pump
规范温度范围为-20℃-+80℃。采用_vE密封材质的液泵较大操作温度可达+60℃C,短时操作时,较大操作温度能够到达+80℃。
The standard temperature range is - 20 (-+80 (-). The maximum operating temperature of the pump with _vE sealing material can reach +60 C, and the maximum operating temperature can reach +80 C in short-term operation.
如在户外温度为0℃或低于0℃的状况下运用,可提供特殊的密封材质。
Special sealing materials can be provided if used at outdoor temperature of 0 or below 0 C.
四、引荐驱动空气质量
IV. Recommendation-driven air quality
依据 PNEUROP(欧洲增压器、真空泵和气驱工具制造商委员会)引荐代号611/1984的规则,驱动气体分3-4个质量类别。
According to the PNEUROP (European Committee of Supercharger, Vacuum Pump and Gas Drive Tool Manufacturers) recommendation code 611/1984, the driving gas is divided into 3-4 quality categories.
颗粒较大颗粒5μ
Maximum particle size 5 u
较大颗粒浓度5mg/m3
Maximum particle concentration 5 mg/m 3
露点+10°=含水量94g/m3+2℃=含水量56g/m3
Dew Point+10 Dew Point=Water Content 94g/m3+2 C=Water Content 56g/m3
含油量1.0-5mg/m3
Oil content 1.0-5mg/m3
留意:当运用湿气或高湿度气体连续操作时,会产生结冰现象,倡议在此种状况下在空气驱动管线上装置一个水别离器或枯燥器。
Note: When using humid or high humidity gas for continuous operation, ice will occur. It is advisable to install a water separator or a dryer in the air-driven pipeline under this condition.
假如驱动空气过于枯燥且露点低于-40℃,倡议运用油雾器。选用优质的驱动气体可以延长气体增压泵密封件的运用寿命。
If the driving air is too dry and the dew point is below - 40 C, it is advisable to use an oil mist. Selection of high quality driving gas can prolong the service life of gas booster pump seals.
感谢您的阅读,此文的文章来源:气体增压泵更多的内容和问题请点击:http://www.lesmills8.com 我们会继续努力的为您提供服务,感谢您的支持!
Thank you for your reading. For more information and questions, please click: http://www.lesmills8.com. We will continue to work hard to provide you with services. Thank you for your support.

13188935873

qq

上海澳贺机械制造有限公司 广东能强陶瓷有限公司 强生搬场运输有限公司 无锡鑫海干燥粉体设备有限公司 新乡市大汉振动机械有限公司 济南精拓流体设备有限公司成都麦森克液压升降机设备生产厂家 上海湘豫过滤设备有限公司 三力士股份有限公司 巩义市晨红机械厂 永春书画装裱厂